Lingenfelter L460095297 Lingenfelter LNC-002 Launch Controller v2.0 - Manual (Page 4)

Page 3 of 17
Switches and indicator lights:
Red (Power) LED:
•
Comes on solid on start-up (power on)
• When active RPM is reached, red LED will blink
(even if activation wire is not triggered)
Green (Activation) LED:
•
slow blink rate (4 Hz) for Launch Activation only
• medium blink rate (8 Hz) for Retard Activation only
• fast blink rate (16 Hz) for both launch and retard
inputs on
Settings:
•
Controlled by two (2) ten position switches (RPM) and two (2) sixteen position switches (Timing)
o Two (2) ten position switches for selecting hundreds of RPM (x100) and thousands of RPM (x1000)
o Two (2) sixteen position switches for selecting retard Degrees and timing retard Rate
Notes:
•
The LNC-002 RPM limiter function will not trigger at RPM levels below 1500 RPM
• The LNC-002 timing retard function will not retard timing below 1000 RPM
• Changes to the switch point settings (RPM, Degrees, Rate) must be done with the ignition off
o The switch positions are only read on start up
Example settings:
• 1900 RPM activation point for launch control
o Upper (x100) RPM switch on position 9
o Lower (x1000) RPM switch on position 1
• 69 00 RPM activation point for RPM limiter
o Upper (x100) RPM switch on position 9
o Lower (x1000) RPM switch on position 6
0
56
789
1234
0
56
789
1234
100's Switch (x100 RPM)
1000's Switch (x1000 RPM)
RPM Programming
Switches
0
56
789
1234
0
56
789
1234
100's Switch (x100 RPM)
1000's Switch (x1000 RPM)
RPM Programming
Switches