Lingenfelter L460145297 Lingenfelter LNC-2001 LS Timing Retard Launch Controller LSA LS9 v1.7 - Manual (Page 8)

Page 7 of 26
Setting The Spark Timing Retard Value
The spark retard amount is set with the Max Retard dial on the box. The settings are as followings:
Position Degrees
0......................0
1......................1
2......................2
3......................3
4......................4
5......................5
6......................6
7......................7
8......................8
9......................9
A ....................10
B ....................11
C ....................12
D ....................13
E ....................14
F ....................15
Setting The Spark Retard Rate
The spark retard rate is set with the Rate switch on the box. The settings are as follows:
• Retard build time settings 0 – 7. Hold and Wait retard, must power unit down after activation to
reset build timer. Retard goes on/off with activation but build timer does NOT reset. Good for drag strip
with nitrous.
Position Rate
0......Retard is immediate.
1..............0.2 second (retard build time)
2..............0.4 second
3..............0.6 second
4..............0.8 second
5..............1.0 second
6............. 2.0 seconds
7............. 3.0 seconds
• Retard build time settings 8 – E. Retard and build timer will reset any time the activation signal is
removed and re-applied.
Position Rate
8..............0.2 second (retard build time)
9..............0.4 second
A .............0.6 second
B ............ 0 .8 second
C .............1.0 second
D ............ 2.0 seconds
E ............ 3.0 seconds
F ........... Linear Mode