Lingenfelter L460145297 Lingenfelter LNC-2001 LS Timing Retard Launch Controller LSA LS9 v1.7 - Manual (Page 22)

• In this configuration, the second stage of nitrous is replaced with the LNC-2001. The second stage must NOT be
progressively controlled.
• Set both stages to the same settings if you want the LNC-2001 timing retard to trigger when the nitrous triggers. If
you want the timing retard to activate earlier or later, set the second stage to come in earlier or later than the first
stage on the controller.
• Use a relay to swap the output (ground/power activation swap)
• This setup can be used for any progressive 2-stage nitrous controller that does not have a timing retard
activation output.
Connecting the Lingenfelter LNC-2001 to a Secondary Stage on the Harris
Speed Works MicroEDGE+ Progressive Nitrous Controller
LNC-2001 Receiving +12V Retard Activation
Input from the Harris Speed Works MicroEDGE+
(Using Two Nitrous Stages)
Ground
85
86
30
87a 87
MicroEDGE+
Driver
Module
Ground
Ground
+12 Volts
Switched
LNC-2001
Red = MAP +5V
Black = MAP/Linear Ground
Purple = MAP/Linear Signal
F = Linear Mode
.2 Volt = 0*
4.8 Volt = 15*
Max Retard
To +12V Side of
Nitrous Solenoid
To +12V Side of
Fuel Solenoid
To Ground Side
of Stage 1
Solenoids
30 Amp
Fuse +12V from
Battery
Stage 1 Relay
85
86
30
87a 87
Stage 2
Relay
30 Amp
Fuse
+12V from
Battery
To Ground Side of Stage 2 Relay
(Stage 2 CANNOT be progressive)
The “MicroEDGE+” name is property of
Harris Speed Works Inc.
Page 21 of 26