Lingenfelter L320030709 Lingenfelter CTS-V Intercooler Radiator Kit 2009-13 v1.1 - Manual (Page 16)

Page 15
45. Position the shrink tube so it overlaps the
end of the loom and some of the hose as
well and then use a heat gun to secure the
loom to the hose. Be sure not to melt the
braided loom with the heat gun. Perform this
step on both ends of the hose.
46. The following steps are done to allow you
to re-clock the bend in the OEM hose in
order for it to attach properly to the new
intercooler. You are sectioning the hose and
placing a hose joiner in between the two
sections of the OEM hose.
Take the OEM 5/8” hose that comes from
the fill reservoir and connects to the inlet of
the intercooler and mark it as shown with a
marking pen.
47. Cut the hose where you marked it in the
previous step.
48. Place a piece of the supplied heat shrink
tube over then hose and then slide one of
the 25.6mm Oetiker clamps (PN: 52545K74)
over the OEM hose and then insert the 5/8”
hose joiner (PN: 9904) into the hose (into
one of the ends you just cut in the previous
step). Slide the remaining 25.6mm Oetiker
clamp (PN: 52545K74) over the other
section of hose and then insert the other
end of the hose joiner into the hose.