Lingenfelter L320030709 Lingenfelter CTS-V Intercooler Radiator Kit 2009-13 v1.1 - Manual (Page 14)

Page 13
37. Take the hose you removed from the
intercooler pump in the previous step.
It should look like the image on the left.
Remove or roll back the mesh sleeve.
39. Cut the hose as marked. Now take the
portion with the tight 90 degree bend on
it (the side that was connected to the
intercooler pump) and slide one of the 27.1
mm (PN: 52545K75) Oetiker clamps over
the hose and then insert the 3/4” joiner (PN:
9905) into the hose as shown. Tighten the
Oeticker clamp in place with Oetiker pliers.
40. Using hose clamp pliers, release the tension
on the constant tension hose clamp and
attach the end of the above hose and joiner
assembly to the outlet (upper) 90 degree
fitting on the side of the intercooler radiator
as shown (the fitting has been clocked to
give better visibility for the picture).
38. Use a silver or white marking pen to mark
the hose as shown on the left.