Laerdal SimPad - Manual (Page 25)

24 25
English
POWER CONNECTION AND HAZARDOUS
VOLTAGE
The product or its accessories may have a hazard-
ous voltage inside.
• Never attempt to open this product, or any
peripherals connected to the product, if this
action requires a tool.
• This product should always be powered from
an earthed power outlet.
• If any parts of the product have visual damage,
never attempt to connect main power, or any
other power source, before consulting service
personnel.
• Route the power cord to avoid it being walked
on or pinched by items placed upon or against
it. Pay particular attention to the plugs, recepta-
cles and the point where the cord exits from
the apparatus.
• Do not tug the power cord.
• If the provided plug does not fit into your
outlet, consult an electrician.
INDUSTRY CANADA RULES
This device complies with RSS-210 of the Industry
Canada Rules. Operation is subject to the following
two conditions: (1) This device may not cause harm-
ful interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
Ce dispositif est conforme à la norme CNR-210
d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet
aux deux conditions suivantes: (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2)
ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
ACCESSORIES
Use only accessories specified by the manufacturer,
or sold with the apparatus.
The RJ-45 jack is not used for telephone line
connection.
FCC STATEMENT
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
The use of shielded I/O cables is required when
connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may
violate FCC rules.
IMPORTANT Changes or modifications not
covered in this manual must be approved
in writing by the manufacturer’s Regulatory En-
gineering Department. Changes or modifications
made without written approval may void the
user’s authority to operate this equipment.