Dell PowerEdge 350 - Manual (Page 27)

support.dell.com Using the System Setup Program 3-7
— Secondary IDE Master — Displays the name of your system’s installed
device, or displays Not Installed. If an IDE device is detected, you can con-
figure the following options: Type (Auto is the default), LBA Mode Control
(Enabled is the default), Multi-Sector Transfers (16 sectors is the default),
PIO Mode (Auto is the default), Ultra MDA (Disabled is the default).
— Secondary IDE Slave — Displays the name of your system’s installed
device, or displays Not Installed. If an IDE device is detected, you can con-
figure the following options: Type (Auto is the default), LBA Mode Control
(Enabled is the default), Multi-Sector Transfers (16 sectors is the default),
PIO Mode (Auto is the default), Ultra MDA (Disabled is the default).
•
Diskette Configuration — Configures the following diskette drive settings:
— Diskette Controller — Enables (the default) or disables the integrated dis-
kette controller.
— Floppy A — Enables (the default) or disables the diskette drive and specifies
its size: 360 KB 5.25”, 1.2 MB 5.25”, 720 KB 3.5”, 1.44/1.25 MB 3.5”, (the
default), or 2.88 MB 3.5”.
— Diskette Write Protect — Enables or disables (the default) write-protect for
the diskette drive.
•
Event Log Configuration — Configures the following event log options:
— Event Log — Displays whether or not space is available in your system’s
event log. This option has no user configurable settings.
— Event Log Validity — Displays whether or not the contents of your sys-
tem’s event log are valid. This option has no user configurable settings.
— Clear All Event Logs — Clears your system’s event log after rebooting. No
is the default option.
— Event Logging — Enables (the default) or disables event logging.
— ECC Event Logging — Enables (the default) or disables ECC event logging.
Security Menu
Selecting the Security option on the menu bar allows you to set the following pass-
word and security features:
•
User Password Is — Displays whether or not your system has a user password
installed (entered). This option has no user configurable settings.
•
Supervisor Password Is — Displays whether or not your system has a supervi-
sor password installed (entered). This option has no user configurable settings.
•
Set Supervisor Password — Specifies a supervisor password that can be up to
seven alphanumeric characters long. The default option is no supervisor pass-
word installed.
•
Set User Password — Specifies a user password that can be up to seven alpha
numeric characters long. The default option is no supervisor password installed.