Konig Electronic Outdoor IP camera remote video surveillance - Manual (Page 3)

ENGLISH
3
Product description:
1. Mount
2. Microphone
3. Antenna
4. IR LED for night vision
5. Camera lens
6. Light intensity sensor
7. WPS/RESET button (behind rubber cover)
8. 12V power cord
User instructions:
A. Hardware Installation
1. Please find a location to install uCare Cam that is within good WiFi signal reach of your
home Router.
2. If you plan to hang the uCare Cam, you can use the included mounting kit found in inside
box.
3. If the included power cable does not have sufficient length to reach power outlet, please
purchase an extender cable from your local electronics store.
4. Connect the camera power adapter.
Warning:
Please use the power adapter included with your camera to avoid damage to
the camera.
When the camera powers up, the status LED will be Green for about 15 seconds before
flashing Red. If there is no Red LED flashing, please unplug the power cord, wait 5 seconds,
then re-connect the power again. It will take about 60 seconds for the uCare Cam to finish
starting up. The status LED should alternate between Red and Green. If the status LED does
not flash Red and Green, please press the WPS/REST button at the back of uCare Cam for
10 seconds.