HITEC H4: DC/DC, Four-Port Multi-Charger - Manual (Page 12)

12
Hitec
Instruction Manual
9CTPKPICPF'TTQT/GUUCIGU
This screen indicates an incorrect polarity connection, please check
the battery polarity again. This screen indicates an interruption in the battery connection,
please check that the battery is connected correctly.
This screen indicates that the voltage is lower than which is set,
check the number of cells in the battery pack.
Please check your battery cell number again.
This screen indicates that the voltage is higher than which is set,
check the number of cells in the battery pack.
Please check your battery cell number again.
This screen indicates that in the Hitec Channel Bridge function, a
voltage level difference occurred between the bridged channels.
Please reset the H4 charger and check the battery as well. This screen indicates that the charger has malfunctioned for some
reason. Contact the Hitec RCD USA customer service department
immediately.
This screen indicates a short circuit in the battery connection or an
internal disconnection. Please make sure all wires are connected
correctly. This screen indicates a mismatch of battery cells between the H4
and the battery. Please make sure battery cells are programmed
correctly.