Hanna Instruments HI 8633 - Manual (Page 3)

3
HI 8633 and HI 8733 have been designed specifically for use in the areas
of production and quality control. It is often necessary to test samples with
different concentrations ranging from deionized water to brine.
Both models can be manually calibrated at 1 point.
The
HI 8733, with a built-in temperature sensor and Automatic
Temperature Compensation, is the perfect instrument for measuring
samples with fluctuating temperature.
HI 8734 has been specially designed for the water conditioning industry,
particularly in the softening, demineralization, reverse osmosis and
drinking water applications.
Three ranges of measurement assure the highest accuracy possible. In
addition, Manual Temperature Compensation is possible through a knob
on the front panel.
The ratio between conductivity and TDS is factory set at 0.5.
Moreover, the 4-ring potentiometric probes supplied with the meters are
made of rugged PVC - ideal for indoor, as well as outdoor measurements.
Remove the instrument from the packing material and examine it
carefully to make sure that no damage has occurred during shipping.
If there is any noticeable damage, notify your Dealer or the nearest
Hanna office immediately.
Each meter is supplied with:
• Conductivity probe with DIN connector and 1 m (3.3') cable:
• HI 76301D for HI 8633 and HI 8734
• HI 76302W for HI 8733
• Calibration solution sachet
• Instruction manual
• 1 x 9V alkaline battery
Note: Save all packing materials until you are sure that the
instrument functions correctly. Any damaged or defective item
must be returned in its original packing materials together
with the supplied accessories.
GENERAL DESCRIPTION
PRELIMINARY EXAMINATION
All rights are reserved. Reproduction in whole or in part is prohibited
without the written consent of the copyright owner.