beautypg.com

0 installation – Hall Research VSA-32 User Manual

Page 7

background image

A / V Switch-Cat

TM

5

3.0 Installation

In a typical installation, the User interface unit is located on a wall or panel and is
wired to the connector panel via 1 Cat5 cable. The connector panel is wired to the
receiver unit via 2 Cat5 cables and 1 Cat5 cable to a compatible UVA sender unit.
The receiver is connected to the VSA-32 power supply

Always refer to the compatible UVA

sender documentation

DO NOT MIX POWER SUPPLIES FROM THE VSA-32 SYSTEM AND THE

COMPATIBLE UVA SENDER. THE VSA-32 SYSTEM USES A 15 vDC POWER

SUPPLY. THE COMPATIBLE UVA SENDER MAY REQUIRE THE USE OF

THE INCLUDED POWER SUPPLY DEPENDING ON THE CABLING AND

VIDEO SOURCE USED. CONTACT HALL RESEARCH IF ANY ASSISTANCE

IS REQUIRED.

The user interface and connector panels qualify as low-voltage class 2 devices
and do not require a J-box in the wall. In fact it does not even need a power
supply to be connected to it, as it draws power via the signal connection to the
remote unit. However, in most instances it is easier to use standard 2-gang and 4-
gang electrical boxes in order to attach the faceplates to the mounting surface or
structure.
Please contact HR or your desired electrical supply house for purchasing the J-
box. These are generally inexpensive units.
As seen in the above diagrams, the connection between the receiver and the
projector could be comprised of VGA, S-Video, and RS232. These cables are not
supplied and must be purchased separately.