Hall Research TVB-350 - Manual (Page 9)

ss TV-to-VGA / HDTV Video Scaler
7
When VCR or non-standard video source is connected to the input
the output picture may be jittering. If this occurs, please turn off the
3D Enhance function.
Digital NR mode: To turn on or turn off the digital noise reduction
function.
2 2 . .
Picture:
Press the button to toggle through picture adjust
parameters as follows:
Contrast > Brightness > Color > Tint > Sharpness
Contrast: Press Ç or È to adjust contrast level. The range of
adjustment is 0~63. Factory default value is 58.
Brightness: Press Ç or È to adjust Brightness level. The range of
adjustment is 0~63. Factory default value is 31.
Color: Press Ç or È to adjust color level. The range of adjustment
is 0~63. Factory default value is 31.
Tint: Press Ç or È to adjust NTSC Tint level. The range of
adjustment is 0~63. Factory defaults value is 31.
Sharpness: Press Ç or È to adjust sharpness level. The range of
adjustment is 0~63. Factory defaults at 10.
3 3 . .
Ç or È: Press to toggle through various adjustment controls to
alter settings
________ Note _______
Under picture adjust mode, pressing Ç and È
simultaneously will revert the selected parameter back to
factory preset value. Pressing both buttons for over 5
seconds will revert all picture parameters back to their
factory preset values.
4 4 . .
IR Sensor: Infrared remote control sensor.
5 5 . .
Power and LED button: Press once to power on the unit, press
again to turn off. Note: with power off the PC input is passed to the
output.