Hall Research UD2A-EDID-S - Manual (Page 8)

6
Model UD-2A-EDID
4.2.1 Configure HyperTerminal
- Connect direct to COM1, COM2, or any available COM
port
- 4800 Baud, 8 bits, No Parity, 1 Stop bit, No flow control
- Settings per following figures:
To enter into the serial command mode after connecting this unit to
the PC; the following text must be sent along with a carriage return
(ENTER).
Hall_Res
When successful, the main menu will display.
MENU - Version x.x
-----------------------------------------
1 = DVI Local | R = Read EDID Info
2 = UTP Remote | B = Blank
3 = Emulate Default | U = Un-blank
4 = Emulate Learned | S = Status Report
L = Learn | M = Menu
E = Enable boost | Q = Quit
D = Disable boost |
-----------------------------------------