Hall Research UD2A-EDID-S - Manual (Page 6)

4
Model UD-2A-EDID
Select the desired EDID routing path using the front panel buttons,
through RS-232 serial commands, or GUI software.
UD2A-EDID Rear Panel
The UD2A-EDID-R does not require a
separate power supply; the power is
supplied by the sender unit via the UTP
cabling. Be sure to connect A and B link
cables correctly! The Green PWR LED
will indicate when the cables are correctly
configured. Once the cabling is correctly
connected, attach a monitor to the receiver
DVI VIDEO OUTPUT connector. Connect
the remote audio device to the STEREO
AUDIO 3.5 mm jack, and a RS232 device
to the 3 pin RS-232 connector; if desired.
4.0 Operation
The UD2A-EDID-S allows multiple control methods, such as front-panel
buttons, RS232 serial commands, or GUI software.
4.1 Front Panel Buttons
The EDID ROUTING button is used to select what EDID information
will be sent to the video source when requested. The choices are:
EDID Routing EDID Information from
DVI-LOCAL
Device connected to the UD2A-EDID-S
OUTPUT DVI Connector
UTP-REMOTE
Device connected to the UD2A-EDID-R
OUTPUT DVI Connector
EMULATE DEFAULT
FACTORY EDID Information stored in
UD2A-EDID-S Unit
EMULATE LEARNED
EDID Information stored by USER from Display
Device either connected locally or remotely and unit
put in LEARN mode
The LEARN button is used to program EDID information from either the
sender’s local OUTPUT DVI connector or the receiver’s Remote