Hall Research UV1-CV - Manual (Page 7)

ss Miniature VGA over CAT5 Extension System
5
2. Installation
1. Connect the VGA in (HD-15) connector of the UV1-Sender to the computer's
video port using the supplied cable (see figure 2.1).
2. Connect the supplied power adapter to the power input connector on either of
the units. Note that only one power adapter is normally needed to power both
the sender and receiver. It can be plugged into either the sender or receiver.
Please be sure to insert the power connector fully. You may need to push
down on the connector as shown below. Check the red light next to the RJ45
connector to verify unit’s power.
Figure 2.2
Figure 2.1