Hall Research UHCOM-WP - Manual (Page 8)

HDMI Extension on UTP
8
7.0 Installation
When using UHBX-R-PSE receiver, please refer to its User Manual
( UMA1215 ) for details on that device including configuration of the Long
Reach mode or details on IR and RS-232 extension.
7.1 Mounting the Transmitter and Heat Dissipation
The UHBX-S-WP comes with a single gang mud-ring. When used in
conjunction with the UHCOM-WP add-on, a two gang mud-ring is supplied.
It is recommended to use the mud rings for installation. The mud ring has no
back so the unit’s rear is not sealed and allows for better heat dissipation.
If for some reason you have to use an electrical box, make sure to use a metal
box with open the holes to allow airflow. Never use a plastic box as it
restricts airflow and insulates the device causing excessive heat build-up that
can shorten the device’s life.
The UHBX-S-WP dissipates approximately 2.5 watts of power, so the unit
will be warm to the touch, this is normal, the temperature is well within UL
limits and the circuit components are designed to operate at these
temperatures. Do not install the unit in a plastic electrical box, though the
device will continue to operate, the elevated circuit temperature may cause
the unit to fail prematurely.
7.1 LED indicators
Link: UTP Link. Solid on means Sender & Receiver are communicating
Video: Off= No Video, Blink = Video without HDCP, ON = Video with HDCP
Note The Decora® units are 1.8” deep and have connectors on the back side.
If a wall box is to be used, we recommend a wall box which has a depth
of at least 2.5 inches to accommodate the connectors and cables.