Directed Electronics Matrix1X - Manual (Page 50)

45 © 2 0 0 8 d i r e c t e d e l e c t r o n i c s
QUICK REFERENCE GUIDE
To arm using your LCD remote
➤ You can activate, or arm, the system by pressing on your remote for one
second. When the system arms, you will hear a short siren sound, or chirp, and the
parking lights will flash once. If the vehicle’s power door locks have been connected
to the system, the doors will lock.
To disarm using your LCD remote
➤ To disarm the system, press . You will hear two chirps, and the parking lights
will flash twice. If power locks are connected to the system, the doors will unlock.
If the siren chirps either four or five times when disarming, see Diagnostics section.
This is called Tamper Alert.
Arming while driving
➤ Press on your remote for two second while the vehicle is running. The system
will chirp once and then once more to indicate that the ignition is on.
Disarming without a LCD remote
➤ Turn on the ignition. Press and release the Valet ® button the programmed number
of times within 15 seconds. After five seconds, the system will disarm. If it does
not, you may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet ® Mode
➤ Turn ignition to RUN position, then turn to OFF position. Press and release the
Valet
® button within 10 seconds. The in-vehicle status LED will light solid if you
are entering Valet ® Mode, and it will go out if you are exiting Valet ® Mode.
To activate Panic Mode
➤ Press and hold or down for approximately two seconds.
To exit Panic Mode
➤ Press or on the remote.
To activate Silent Mode™
➤ Press briefly before arming or disarming, and the confirmation chirp(s) will
be eliminated for that one operation only.
Location of Valet ® Button_______________________________
Number of Valet ® Button pulses for disarming_____________
Cut along dotted line and f
old f
or a quick and eas
y
r
efer
ence to k
eep in y
our pur
se or w
allet.
✂ ✂
✂✂