Valet mode – Directed Electronics Matrix1X User Manual

Page 29

Valet mode

You can prevent your security system from automatically arming

and triggering by using Valet Mode. This is very useful when

washing the vehicle or having it serviced. In Valet Mode, the

security system will not arm, even with the remote transmitter,

but all convenience functions (door locks, trunk release, etc.)

will continue to work normally.

To enter or exit Valet Mode:

1. Turn the ignition on.

2. Turn the ignition off.

3. Press and release the Valet

button within 10 seconds.

The status LED will light solidly if you are entering Valet Mode,

and it will go out if you are exiting Valet Mode.

The remote will respond with 5 flashes of the

icon and 2

beeps on entering or exiting Valet

Mode.

To enter or exit Valet Mode using the transmitter:

1. Open any vehicle door.

Quickly press the following buttons in the sequence indicated.

2. Press .

3. Press .

4. Press again.

The in-vehicle status LED will light solidly if you are entering

Valet

Mode, and it will go out if you are exiting Valet

Mode.

DRW-35

➜