Denon AVR-985 - Manual (Page 22)

22
1-1 Setting the Auto Setup
3 Check the "Power Amp Assign" setting.
• When “Surround Back" is selected, the test tone during Auto Setup will be output from the Surround Back speaker.
• When “ZONE2” is selected, change the setting to "ZONE2” The test tone during Auto Setup is set so that it will not be output to
ZONE2 (Another room).
1 Select “Auto Setup” at the Auto Setup / Room EQ Menu.
(Remote control unit)
A u t o S e t u p
* A u t o S e t / R o o m E Q
(Remote control unit)
q Select the Power Amp Assign setting.
w Select “Surround Back” or “ZONE2”.
(Remote control unit) (Remote control unit)
P . A m p : S B
* A u t o S e t u p
4 q Select the “Start”.
(Remote control unit)
S t a r t
* A u t o S e t u p
(Remote control unit)
2 Display the Auto Setup screen.
w Press the Cursor left button.
NOTE:
• When “ZONE2” is selected at System Setup Menu
“Power Amp Assign”, surround back speaker is not
displayed as the target of setup in “2-1.Speaker
Config.”. The results is reflected in “5-1.Power Amp
Assign”.