Directed Electronics MAXX3 - Manual (Page 9)

®2002 Directed Electronics, Inc. 9
The built-in Dual Circuit Immobiliser will passively arm (indicated by
a slow LED flash), 30 seconds after the ignition is turned off. (This
feature is a Thatcham and EC requirement and, therefore, is not
user-programmable.) To disarm the Immobiliser when it has
Passively Immobilised, use the remote control to arm and then dis-
arm the system, or turn the ignition on and press the button.
The Valet switch is a small push-button switch that allows you to
control all of the system’s programmable features and enter your
override PIN code. (See User-Programmable Features section of this
guide.) This switch can only be controlled in conjunction with
your ignition key.
NOTE: Make sure the dealer has shown you where the Valet switch is
located. You will need to disarm the system with the Valet switch in the
event of a lost or stolen remote control.
While the system is in the Valet mode, you can still use your
remote control to lock and unlock the doors as well as activate any
optional accessories, such as boot release or remote engine
starter.
Your Maxx3 security system incorporates two Ultrasonic sensors,
which are most commonly mounted at the top of the A-pillars fac-
Ultrasonic Sensors
Keyless Entry in Valet Mode
Valet Switch
Passive Immobilisation