Directed Electronics MAXX3 - Manual (Page 24)

®2002 Directed Electronics, Inc. 24
How to Set the User-
Programmable Features
All system features and remote control features are accomplished
by turning the ignition key to the ON position or starting the
engine, entering your Personal Identification Number (PIN) and
pressing the Valet switch a preset number of times to access the
feature you wish to program.
The system also allows you to add new remote controls in one step
and delete lost or stolen remote controls.
1. Programming cannot be accessed while the system is in
Protected Valet Mode indicated by the LED on solid red.
Remove the system from Protected Valet Mode by turning on
the ignition. The LED should turn off automatically.
2. Select the feature you wish to program from the Programming
Table for System Features or the Programming Table for Remote
Controls. Note the number of chirps associated with that feature.
3. To enter programming mode, enter your existing PIN code
number by following steps 1-12 in the Protected Valet Mode
section of this guide.
4. Turn the ignition key ON.
5. Begin to press and release the Valet switch. The siren will
chirp once each time you press and release the Valet switch.