ENMET LC-8 - Manual (Page 3)

LC S ERIES ENMET
1
1.0 Introduction
The LC Series Control Units that provide facilities to monitor a wide variety of industry standard environmental and other
sensors.
 The LC1 provides 1 monitoring channel.
 The LC2 provides up to 2 monitoring channels.
 The LC4 provides up to 4 monitoring channels.
The LC-Series Controller has been designed to allow the use of any ENMET sensor transmitter and has been
preprogrammed to match the sensor transmitters supplied at time of delivery. The LC-Series can also be used with any
manufactures sensor transmitter that can produce a voltage or current output within a specified range; however it is advisable
that you contact ENMET for proper setup and programming instructions.
Care has been taken with the design of the MCU housings and internal chassis to facilitate ease of connection and wire
termination. All on-site wiring to the system is via screw terminal connectors. The terminal cover has an internal label giving
details of the external connections.
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the LC S ERIES and examine it for shipping damage. If such damage is observed, notify both ENMET customer
service personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
 This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in
good condition.
 When it was picked up by the carrier at ENMET, it legally became your company’s property.
 If your shipment arrives damaged:
 Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
 After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase Order and Sales
Order numbers available.
 ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage,
usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
 The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a written
request to ENMET Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days of
receipt at the following address:
ENMET
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the LC S ERIES is received as ordered. Each LC
Series Control Unit is labeled with its target gas. If there are accessories on the order, ascertain that they are present. Check the
contents of calibration kits. Notify ENMET customer service personnel of any discrepancy immediately.
1.3 Serial Numbers
Each LC S ERIES is serialized. These numbers are on tags on the equipment and are on record in an ENMET database.