ENMET EX-5100 - Manual (Page 9)

EX-5100 C OMBUSTIBLE ENMET Corporation
7
4.2 Normal Display Mode
When the EX - 5100 is installed as described in section 3, and in clean air, the POWER green LED is on, the display is lit and
the information on the display is measurement of the target gas detected by the EX - 5100. The red alarm and fault LEDs are
not lit.
To advance through displays of operational information tap the magnet over the M ENU button.
N OTE : Software revision may cause variations of display output.
See sequence of operational information below:
Display Measurement of the target gas
Tap the magnet over the M ENU button
Display indicates Alarm 1 Set point
Tap the magnet over the M ENU button
Display indicates Alarm 2 Set point
Tap the magnet over the M ENU button No Function for the
S ELECT button
in this mode
Display indicates Alarm 3 Set point
Tap the magnet over the M ENU button
Display indicates mA Span range
(Full Scale)
Tap the magnet over the M ENU button
Display returns to gas measurement
Operational Display Flow Chart
4.2.1 Alarm Conditions EX - 5100
There are three alarm set points available. These alarm set points can be changed within limits; see the maintenance section of
this manual for the procedure.
If the gas concentration increases above that of the alarm set point, the associated red LED is lit.
0LEL
A1: 10
S ELECT
S ELECT
M ENU
M ENU
A2: 20
S ELECT
M ENU
A3: 50
S ELECT
M ENU
mA: 100
S ELECT
M ENU