Elenco Bigshot Camera - Manual (Page 9)

6 7
Place the connectors from the
dynamo and the battery into the
space at the bottom of the camera
body. Make sure that the wires do
not touch the gears.
Place the clear back cover on top of
the camera body. Make sure the
screw holes on the cover align with
the screw inserts on the camera
body.
Fasten the back cover with four
screws.
Build
C10. Now set the battery into the camera
body as shown.
C11.
C12. C13.
C Electronics
If you want to disconnect the wires,
then press down on the smaller
connector and pull it out as shown
above.
C8. Take the remaining connector from
the PCB module and the connector
from the battery. Gently connect the
connectors so that they click.
C9.
Learn about rechargeable battery
http://www.bigshotcamera.com/learn/power/battery