Elenco Bigshot Camera - Manual (Page 8)

6 7
Pick up the PCB module and turn
the mode knob to the position
shown above.
Fasten the PCB module onto the
camera body using three screws.
Now set the mode knob to the OFF
position. It must remain in the OFF
position during the remaining
assembly process.
Build
C3. Insert the PCB module into the camera
body. Make sure the pillars in the
camera body go through the holes in
the PCB module.
C4.
C5. C6.
C Electronics
Learn about LCD
http://www.bigshotcamera.com/learn/lcd-display/index Learn about electronic components
http://www.bigshotcamera.com/learn/electronics/index
Find the connector attached to the
pair of wires from the PCB that have
the same color combination as the
wires from the dynamo. Hold the two
connectors in each hand and gently
join them until they click.
C7.