Elenco Bigshot Camera - Manual (Page 5)

2 3
Slide gear A into the hole on the side
of the camera body. The blue arrow
tells you the direction in which to
slide the gear.
Place gear C next to the first gear as
shown, and push the rod through
both the gears until it is all the way
in. The left end of the axle should
now sit in the notch on the camera
body and the two gears should be
free to spin.
Take gear B and gear D and hold
them together as shown. Now push
the second axle rod through both
gears such that it pops out just a bit
at the other end.
Build
B1. While holding the gear in place with
one finger, insert one of the axle rods
into the middle hole of the gear. Push
the rod in until it touches the finger
holding the gear.
B2.
B3. B4.
Take the gear assembly you just
made and place it below the first set
of gears, as shown. Make sure the
left end of the rod rests in the notch
in the camera body.
B5.
B Power Generator
Learn about gearbox
http://www.bigshotcamera.com/learn/power/gearbox Learn about gears
http://www.bigshotcamera.com/learn/power/gears