Elenco DataCom Tester Kit - Manual (Page 22)

-21-
SECTION G - FINAL ASSEMBLY OF TESTER
r Push the button cap onto the switch as shown in Figure O.
r Mount the PC board to the top case, as shown in
Figure P, with two 2.6 x 8mm phillips screws.
Note: The button cap should be centered in the
top case hole. Make sure that the Lo Batt LED
goes through the hole in the case.
r Wrap the wires from the battery snap around the
battery housing as shown in Figure Q.
r Mount the bottom case to the front case, as
shown in Figure Q, using four 3 x 12mm flat
phillips screws. Be sure that the battery snap is
through the battery compartment hole as shown.
r Connect the 9V battery to the battery snap and
place it into the case. Slide the battery cover onto
the case as shown in Figure R.
Figure O
Figure P Figure R
2.6 x 8mm Screws
PC Board
Top Case
Battery Cover
9V Battery
Button Cap
Bottom Case
3 x 12mm Screws
Figure Q