Elenco Soldering Station - Manual (Page 11)

-10-
Cut the 2”, 1/4" dia. shrink tubing into two 1” pieces.
Determine which type of AC receptacle you
received in your kit (type A or B). Solder a 4” red
wire to lug #2 as shown in Figure K.
Snap the AC receptacle into the opening on the
back as shown in Figure L.
Insert the line cord strain relief into the case as
shown in Figure L.
Slide one piece of the 1/4” dia. tubing over the white
line cord wire and attach the wire to lug #1 as shown
in Figure M. Do not solder it yet.
Insert a 4” white wire from the switch through the
tubing with the white wire and attach it to lug #1 (see
Figure M).
Solder both white wires to lug #1. Now slide the
shrink tubing over the connection and shrink it into
place (see Figure M).
Slide the other 1/4” tubing over the red wire
soldered on the AC receptacle. Shrink the tubing
over the connection (see Figure M).
AC RECEPTACLE ASSEMBLY
Figure L
AC
Receptacle
Strain Relief
Figure M
Heat Gun
White Wire
from Switch
White Wire
4” Red Wire
1/4” Shrink Tubing
Figure K
Back of AC Receptacle
Back of AC Receptacle
4” Red Wire
3
1
2
1
3
4” Red
Wire
2
Type A
Type B