Elenco Rhinoceros Mini-Beest Kit User Manual

Page 19

Attach the single-action rods (lower) to the lower

triangles. Be sure to check the orientation.

From this step onward, the figures are drawn with the lower triangle (with leg tube)

facing out toward you.

The figures below are drawn with the upper triangle facing out

toward you once again.

Attach the two legs to the protrusions on the

frame in the same way as Step 1.

Attach the frame to the legs and fix it to the

axes of the crankshafts. Then, attach four

single-action rods in the same way as described

in Steps 4 to 9.
Make sure to attach in the right locations and

directions.

Attach the single-action rod (lower) on the left side

just above the single-action rod (lower) that was

attached in Step 8.

Attach the single-action rod (lower) on the right side

to the first crank pin on the crankshaft. Attach it

between the two single-action rods (upper) that were

attached in Steps 5 and 6.

Single-action rod

(Lower)

Single-action rod (Lower)

Single-action rod

(lower)

Single-action rod

(upper)

Frame

There is a step.

Smooth surface

The notch is directed slightly

toward the inside.

Lower

triangle

Lower

triangle

Indent

Attach in the same direction as the two legs that have

already been attached.

It may be difficult to attach

the frame as the crankshaft may

get in the way.

Orient the frame with the protrusion with the indented tip side up when attaching.

This is a picture of the

unit assembled

correctly up to this

point.

IMPORTANT

Single-action rod (upper)

Single-action rod (lower)

Make sure that the two

single-action rods (lower) are

located between the two single-

action rods (upper).

MINI RHINOCERO