Electrocompaniet ECT 2 - Manual (Page 4)

4
1.3 Before you start to use the system
Step 1
First of all you need to activate the batteries. Please remove the
plastic stick located on the right side.
If your remote controller came without installed batteries please fol-
low the description "Installing the batteries"
Step 2
The next to do is to charge the remote controller. This has to be
done as described in the chapter "charging the batteries".
Step 3
When you are finished with step 1 and , you are ready to learn the
ECT- what units that is to be included in the communication list.
Please follow the procedure in chapter “Connecting the remote
controller” for this process.
When you are finished with these three steps you are ready to start
to use the remote controller.
However, we strongly advice you to read this manual carefully
before you start to use the product !
General use