beautypg.com

Operation, Caution, Warning – EarthQuake MC43ES User Manual

Page 13: 800 watt inverter generator, Starting generator

background image

Operator’s Manual

800 Watt Inverter Generator

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5

13

RUN

CHOKE

primer bulb

OPERATION

STARTING GENERATOR

Before starting make sure nothing is connected to the genera-

tor and it is in a stable position. The economy control switch

should be in the OFF position until the generator and the later

connected devices are running smoothly.
1. Turn the fuel tank cap air vent to the OPEN position.

SEE FIGURE 4

2. Turn the fuel valve to the ON position. SEE FIGURE 4
3. Turn the engine switch to the ON position. SEE FIGURE 5
4. Press the primer bulb six times with the choke in the RUN

position. SEE FIGURE 6

NOTE: Priming the engine should only be necessary for cold

starts and after refueling.

5. Move choke lever to the CHOKE position. SEE FIGURE 6

NOTE: Not necessary if the engine is warm.

6. Use one hand to securely hold the carrying handle of the

generator. With the other hand pull the starter handle slowly

until resistance is felt (this is the “compression” point). Return

the handle to its original position and then pull swiftly. Do no

fully extend the rope. After starting, slowly return the starter

handle to its original position.

NOTE: If the engine does not start prime again and repeat.

7. Allow the engine to warm up.
8. Move choke lever back to the RUN position. SEE FIGURE 6
9. Allow for the engine to run without a load for a few minutes.

NOTE: For cold weather operation, store the unit in a cool

environment. Transferring the unit from a cold to a warm

place can cause the build up of harmful condensation.

TO STOP THE GENERATOR

1. Disconnect any electrical devices.
2. Flip the engine switch to the STOP position. SEE FIGURE 5
3. Turn the fuel valve to the OFF position. SEE FIGURE 4
4. Turn the fuel tank cap air vent counterclockwise to the

CLOSED position. SEE FIGURE 4

CAUTION

IF ENGINE FAILS TO START AFTER FOLLOWING START-

ING PROCEDURES, PLEASE CONTACT OUR CUSTOMER

SERVICE DEPARTMENT AT 800-345-6007.
STARTER ROPE CAN CAUSE AN UNANTICIPATED JERK

TOWARDS ENGINE. PLEASE FOLLOW INSTRUCTIONS

TO AVOID INJURY.
NEVER LEAVE ENGINE RUNNING WHILE UNATTEND-

ED. TURN OFF AFTER EVERY USE.
NEVER CARRY GENERATOR FROM ONE LOCATION TO

ANOTHER WHILE ENGINE IS RUNNING.
ALWAYS WEAR A PROTECTIVE HEARING DEVICE.
DO NOT START ENGINE IF FUEL IS SPILLED. WIPE OFF

EXCESS FUEL AND ALLOW TO DRY.
STARTING THE GENERATOR WITH ELECTRICAL DE-

VICES CONNECTED COULD DAMAGE THE GENERATOR

AND THE CONNECTED DEVICES.

WARNING

MAKE SURE THE UNIT IS IN A STABLE POSITION BE-

FORE PULLING THE STARTER HANDLE.

FIGURE 6

FIGURE 5

ENGINE SWITCH

ECON. SWITCH

DC PROTECTOR

ON

OFF

CL

OS

E

O

PE

N

CLOSE

OPEN

ON

OFF

FIGURE 4

This manual is related to the following products: