DuraVent DuraTech 5-8 - Manual (Page 18)

18
Twist lock the Finishing Collar on to the
female end of the Chimney Branch by twisting
clockwise.
8. Complete Chimney: Attach the Chimney
Sections as in Step 7 in the Ceiling Supported
Installation section. Secure the chimney to
the wall with Wall Straps at a minimum of 8’
intervals and maintain at least 2” of clearance
to combustible materials. The various support
components are adjustable in length from
the wall to better fit your installation. Slip the
Wall Straps around the chimney, tighten the
bolts, adjust the clearance, and fasten the Wall
Straps to the wall with (4) #8, 1-1/2” long wood
Figure 25
USE 1/2”
SHEET METAL
SCREWS TO
SECURE BAND
TO SUPPORT
BASE
USE (4) 1/2”
SHEET METAL
SCREWS TO
SECURE BAND
AROUND
CHIMNEY
CLEANOUT CAP
INSTALLATION WITH TEE
BELOW TEE SUPPORT
(SHOWN WITH LEG
BRACKETS MOUNTED
ABOVE SUPPORT
PLATE)
TEE SUPPORT MAY BE
INSTALLED WITH LEG GUSSETS
ABOVE OR BELOW SUPPORT
PLATE AS SHOWN
8-PENNY NAILS OR #8, 2 1/2”
WOOD SCREWS, 4 PER SIDE
ADJUSTABLE TEE
SUPPORT
ADJUSTABLE WALL STRAP,
8-PENNY NAILS OR #8,
2 1/2” WOOD SCREWS,
2 PER SIDE
Figure 24
FINISHING COLLAR
TEE CAP
CHIMNEY SECTION
CHIMNEY TEE
USE 8 PENNY NAILS OR #8, 2 1/2” WOOD
SCREWS. USE 4 FOR EACH SUPPORT LEG.
TEE BRANCH (MUST
PENETRATE A MINIMUM
OF 6 INCHES INTO ROOM)
WALL THIMBLE
ASSEMBLY
TEE SUPPORT IS ADJUSTABLE FOR
DISTANCE FROM CHIMNEY TO WALL.