Ditch Witch RT120 - Manual (Page 4)

RT120 Operator’s Manual
Overview - 3
Intended Use
CMW
Intended Use
The RT120 is a riding trencher designed to install buried service lines of various sizes using a variety of
Ditch Witch attachments.
This unit is designed for operation in temperatures typically experienced in earth moving and construction
work environments. Provisions may be required to operate in extreme temperatures. Contact your Ditch
Witch dealer.
Use in any other way is considered contrary to the intended use.
The RT120 should be used with genuine Ditch Witch chain, teeth, and sprockets. It should be operated,
serviced, and repaired only by persons familiar with their particular characteristics and acquainted with the
relevant safety procedures.
Equipment Modification
This equipment was designed and built in accordance with applicable standards and regulations.
Modification of equipment could mean that it will no longer meet regulations and may not function properly
or in accordance with the operating instructions. Modification of equipment should only be made by
competent personnel possessing knowledge of applicable standards, regulations, equipment design
functionality/requirements and any required specialized testing.
The protection offered by the Rollover Protective System (ROPS) will be impaired if it has been subjected
to any modification, structural damage, or has been involved in an overturn accident. The ROPS must be
replaced after a roll-over.
Attachment Max. width/diameter Max. depth*
H910 trencher 24” (610 mm) 100” (2.5 m)
H911 trencher 24” (610 mm) 96” (2.4 m)
H932 plow 3” (80 mm) 36” (915 mm)
H952 combo
trencher 12” (305 mm) 70” (1.8 m)
plow 3” (76 mm) 36” (915 mm)
H1140 saw 6” (150 mm) 40” (1000 mm)
RC120 reel carrier
A920 backhoe 24” (610 mm) 109” (2.4 m)