Finish plowing, Rt120 operator’s manual – Ditch Witch RT120 User Manual
Page 117
Plow - 116
RT120 Operator’s Manual
Operation
CMW
Finish Plowing
1.
When installation is complete, move plow swing out of float.
2.
With vibrator running, raise plow to ground level.
3.
Move attachment speed/direction control to neutral.
4.
Swivel seat to the drive position.
5.
Engage parking brake and verify parking brake indicator is on.
6.
Lower backfill blade, if equipped.
7.
Turn ignition switch to STOP and remove product from plow.
8.
Swing plow to center position and engage swing lock and stow lock.
9.
Raise backfill blade, if equipped.
10. Disengage axle lock.
11. Drive a short distance away from work site.
12. Shut down tractor. See page 88 for proper shutdown procedures.
NOTICE: Do not operate vibrator when plow is out of the ground. This will cause excessive
vibration resulting in rapid wear, and possible damage to the unit and product being installed.
IMPORTANT: Drive tractor in reverse 6’ (2 m) while turning steering wheel left to right to fully
disengage axle lock.