DaySequerra MultiMerge2 - Manual (Page 8)

8
MultiMerge2
User
Manual
The AC power cable supplied with MultiMerge2 must be connected from the IEC320 power entry
module to an AC mains outlet with a functional earth ground connection. For protection against electric
shock and electro-magnetic interference, do not plug the power cable into a ground lifting adapter or
remove the cable’s grounding pin. If in doubt, please consult a qualified electrician.
Please connect MultiMerge2 to an uninterruptible power supply (UPS) to protect against power
surges and low-voltage conditions. MultiMerge2 may be combined with other devices on the output
of the UPS as long as the total load is within the UPS’ capacity. Consult your UPS manual for details.
MultiMerge2 will automatically power up when AC power is applied. If AC line power is lost or
momentarily interrupted, MultiMerge2 will revert to its previous state.
Front
Panel
Controls
and
Indicators
Meters
INPUT LEVELS - Eight 10-segment multi-colored LED meters display the audio level for each channel
of the inbound audio stream.
Figure
1.
LED
Meters
on
Multimerge2
INPUT LEVELS – LED display shows current amplitude of input signal from
-60dB to 0dB across all active channels. Unused channels will not light the display.
L - Left (AES Input 1) Ls - Left Surround (AES Input 5)
R - Right (AES Input 2) Rs - Right Surround (AES Input 6)
C - Center (AES Input 3) L - Stereo Left (AES Input 7)
LFE - Low Frequency (AES Input 4) R - Stereo Right (AES Input 8)