DaySequerra MultiMerge2 - Manual (Page 10)

10
MultiMerge2
User
Manual
Display
and
Controls
VACUUM FLUORESCENT DISPLAY - A Multi-function display will indicate current status of the unit
and programming menus.
SELECTION KNOB - A stepping rotational knob is used to select values while in the menu system. To
enter the menu, simply rotate the knob in any direction while MultiMerge2 is on the HOME screen.
ENTER KEY - Used to enter a menu or confirm a selection.
HOME KEY - A press of this button will return MultiMerge2 to the home screen or enter home screen
selection mode.
BACK KEY – This key will return to a previous menu, or if you are entering a value, exit the field and
return the value to the last programmed state.
HEADPHONE JACK – Accepts any headphone or monitor that has a 3.5mm stereo mini-jack
connection. Volume control is software based, adjusted within the home screen selection mode.
Rear
Panel
AES INPUTS - Four 75Ω BNC connectors will accept an AES3 digital audio stream with 1 AES-3/AES-
11 input for external AES sync and 1 AES-2 PCM input for EAS/CAP. (1 HD/SDI Input is available as
an option)
• 1/2 - Left and Right Channel
• 3/4 - Center and LFE
• 5/6 – Left and right Surround
• 7/8 – Aux/Stereo
AES OUTPUTS - Four 75Ω BNC connectors output the AES3 digital audio stream. (1 HD/SDI Pass-
through output with option)
• 1/2 - Left and Right Channel
• 3/4 - Center and LFE
• 5/6 – Left and right Surround
• 7/8 - Aux/Stereo
The AES-3id-1995/SMPTE 276M standard dictates a 75Ω unbalanced connection and requires proper
termination. The termination should occur at the destination of the signal (that is, on the inputs to
Multimerge2). If the loop-through BNC connectors are not feeding additional equipment, terminate each
of these with a standard 75Ω terminator. Like other inputs, HD/SDI signal should be terminated.