DaySequerra MultiMerge2 - Manual (Page 14)

14
MultiMerge2
User
Manual
of letters (A-Z, 0-9 and _ (underscore)) and press ENTER to move on to the next field. Turning the knob
again will start to scroll through the choices for the next letter, or pressing ENTER accepts the name.
DHCP: Configures MultiMerge2 to look for a DHCP server for IP configuration. (Enabled or Disabled)
IP Address: If DHCP is set to disabled, allows you to enter the desired IP address manually. Press
ENTER while the cursor is over this field to go into data entry mode. Scroll through the available
numbers (0-255) and press ENTER to move to the next octet.
MAC Address: Displays MultiMerge2’s MAC address if needed for firewalls or DHCP IP address
assignments.
Diagnostics
Menu
Figure 7. Diagnostics Menu Screen Display
Current Faults: Displays any error states that MultiMerge2 may be in.
DSP Utilization: Shows the current load on MultiMerge2’s DSP.
UpMix Latency: The time is takes the algorithm to process audio in UpMix
Meter Brightness: Allows adjustment of MultiMerge2’s Input and Output meters.
Display Brightness: Allows adjustment of MultiMerge2’s display output.
Restore Settings: Returns all settings to their factory default values and reboots the unit. Network
settings will not be lost.
GPIO Test: A sub-menu that turns on the ALARM outputs for testing.