DaySequerra MultiMerge2 - Manual (Page 13)

MultiMerge2
User
Manual
13
Settings
Menu
Figure 5. Settings Menu Screen Display
Settings that may be controlled on MultiMerge2:
5.1 Final Limiter: A final limiter is present to control the absolute waveform peak level for the surround
output. This parameter controls the output peak level in dBFS
2.0 Final Limiter: A final limiter is present to control the absolute waveform peak level for the stereo
output. This parameter controls the output peak level in dBFS
Noise Floor: The Noise floor parameter prevents increasing the noise floor level. Input signals below
the threshold are considering too low and are not managed by the loudness processing to avoid
bringing up the noise level. Input signals above the Noise Floor are considered valid and are managed
by the loudness processing.
Cross Fade Time: Determines the speed at which transitions from UpMix to Passthrough mode occur.
Network
Menu
Figure 6. Network Menu Screen Display
The DaySequerra MultiMerge2 has several configurable network settings. All of MultiMerge2’s network
settings are password protected. The password to change the network settings is “merge123”. Please
take note when entering the password that the MultiMerge2 password is case sensitive. The
DaySequerra MultiMerge2 is configured to take a DHCP address by default.
Device Name: Allows you to change MultiMerge2’s name as reported to DNS. Press ENTER while the
cursor is over this field to go into data entry mode. Turn the knob to scroll through the available choices