Bullard H1000OEM - Manual

USER INSTRUCTIONS for the Fire Service
Helmet H1000OEM and H2000
www.bullardextrem.com
Thank you for choosing a fire service helmet from Bullard.
Protection helmets are an integral element of personal safety equipment and
help prevent, or at least reduce, head injuries.
Please spare some time to read the following information so you can
properly adjust your helmet. It has been written with both your safety and
comfort in mind.
Head Size, size adjustment and weight
The helmet can be adjusted infinitely to any head size from 52 –64 cm.
Total weight with no accessories is approx. 900g.
First adjust the size range on the headband.
H1000OEM model with pin lock
Loosen both ends of the headband from one another and move them to the
required size.
Then press the two end pieces firmly onto the pins again.
H2000 model with
SURE LOCK® ratchet system
Open the wheel ratchet counterclockwise.
Put on your helmet and turn the wheel ratchet clockwise until it rests firmly
yet comfortably on your head.
Adjusting the height
The crown straps can be adjusted
lengthwise so as to adjust the
height of the helmet.
Set the straps so that around
10-20mm of air remains between
the skullcap and inner shell of the
helmet, with the headband not
touching the base of the ears.
Chin strap
Adjust the strap so that two fingers can fit between
the strap and chin.
Always fasten the loose end of the belt strap.
Put on your helmet and locate the female portion of the strap buckle A.
Slide the strap through the loop in the back of the helmet until the buckle
rests roughly 1.5 cm below your ear. Make sure that both sides of the strap
leading into the buckle lay flat against one another.
Find the male portion of the buckle. It should also be placed roughly 1.5 cm
below the ear, and both straps leading to this buckle should lay flat against
one another.
Close the snap lock and adjust the belt length via the loose end of the
looped-round
belt strap C on
the snap lock.
The helmet meets standard
requirements on retention system
effectiveness and strength as long as
the chin strap is adjusted as mentioned
above and 2 fingers fit in between chin
strap and chin.
B
A
B
C
C
A