Dynex DX-E402 - Manual (Page 5)

Setting up and using your router 5
Warning: Unplug your router and keep your hands dry to avoid electrical shock.
To connect your hardware:
1 Turn off your computer(s), your cable or DSL modem, and the router. You may need to
unplug the device if no power switch is available.
2 Locate the Ethernet cable that connects your modem and computer. Unplug that cable
from your modem, and plug it into LAN Port 1 port on the back of the router.
3 Connect the supplied Ethernet cable to on the WAN port back of the router.
4 Connect the other end of the supplied Ethernet cable to your modem, in the port that's
now free.
5 If needed, connect additional computers, switches, or hubs to the LAN ports on the
router.
6 Connect the power adapter to the power connector on the back of the router, then
plug the other end into a power outlet. The router starts to work automatically.
RESET
Switch or Hub
To LAN 1
To WAN
LAN
To power
Internet
To LAN
XDSL Cable
Ethernet