Avalue EEV-EX03 - Manual (Page 37)

Quick Installation Guide
EEV-EX03 Quick Installation Guide 37
Signal PIN PIN Signal
SIDE_D1 D61 D62 PIDE_D14
SIDE_D13 D63 D64 PIDE_D1
GND D65 D66 GND
SIDE_D2 D67 D68 PIDE_D13
SIDE_D12 D69 D70 PIDE_D2
SIDE_D3 D71 D72 PIDE_D12
SIDE_D11 D73 D74 PIDE_D3
SIDE_D4 D75 D76 PIDE_D11
SIDE_D10 D77 D78 PIDE_D4
SIDE_D5 D79 D80 PIDE_D10
+5V D81 D82 +5V
SIDE_D9 D83 D84 PIDE_D5
SIDE_D6 D85 D86 PIDE_D9
SIDE_D8 D87 D88 PIDE_D6
GPE2# D89 D90 PIDE_P#
RTD- D91 D92 PIDE_D8
RTD+ D93 D94 SIDE_D7
TXD- D95 D96 PIDE_D7
TXD+ D97 D98 HDRST#
GND D99 D100 GND
2.3.33 Signal Description – ETX Connector 4 (ETX4)
2.3.33.1 Ethernet Signals
Signal Signal Description
TXD#, TXD
Ethernet Transmit Differential Pair. These pins transmit the serial bit stream on the
Unshielded Twisted Pair (UTP) cable. The current-driven differential driver can be
two-level (10BASE-T) or three-level (100BASE-TX) signals depending on the
mode of operation. These signals interface to the Ethernet cable through an
isolation transformer.
RXD#, RXD
Ethernet Receive Differential Pair. These pins receive the serial bit stream from the
isolation transformer. The bit stream can be transmitted in either two-level
(10BASE-T) or three-level (100BASE-TX) signals depending on the mode of
operation. These signals interface to the Ethernet cable through an isolation
transformer.
ACTLED
The Activity LED pin indicates either transmitted or received data activity on the
Ethernet port.
This pin is asserted low when activity is detected. It can sink 5mA to ground
through an external LED and a limiting resistor to a 3.3V source.
LILED
The Link Integrity LED pin indicates link integrity. This pin is asserted low when the
link is valid. It can sink 5mA to ground through an external LED and a limiting
resistor to a 3.3V source.