Avalue BFC-10R1 - Manual (Page 35)

User ’s Manual
RSC-IMX51 User ’s Manual 35
3.6 Configuring Ethernet Connection for Downloading and Debugging
To configure an Ethernet connection that can be used for downloading and debugging images,
follow these steps:
 From the Platform Builder Target menu, choose Connectivity Options.
 Choose Kernel Service Map.
 In the Target Device box, choose a target device.
 In the Download box, choose Ethernet as the download service.
 Launch EBOOT on the target. After EBOOT initialization completes, BOOTME
messages begin to appear on the serial debug output. Observe the device name created by
EBOOT on the serial debug output.
 To the right of the Download box, choose Settings. The device name of the target should
appear in the Active Devices box.
 Select the target from the Active Devices box, and then choose OK.
 In the Transport box, choose Ethernet as a kernel transport.
 To the right of the Transport box, choose Settings.
 Check the box next to Use device name from bootloader and then choose OK.
 If the run-time image includes support for the kernel debugger stub, KdStub, from the
Debugger box, choose KdStub. If the run-time image does not include support for a
debugger, from the Debugger box, choose None.
 Choose Core Service Settings. To instruct the Platform Builder to download a run-time
image each time the Platform Builder connects with the target device, under Download
Image, choose Always.
 Select Enable KITL on device boot.
 Select Clear memory on soft reset.
 Select Enable access to desktop files.
 Choose Apply.
 Choose Close.
 Click Target => Attach Device, then RSC-IMX51 will start to download NK.bin from
WinCE6.0 platform builder automatically.