Avalue BFC-10R1 - Manual (Page 33)

User ’s Manual
RSC-IMX51 User ’s Manual 33
3.4 Program XLDR and EBOOT in on-board flash Using ATK Tool
Follow these steps to program XLDR and EBOOT in onboard SD card using the ATK Tool:
 Connect USB cable from mini-USB connector(J1) of RSC-IMX51 to your development
workstation.
 Set SW2 of RSC-IMX51 in USB OTG mode and power on it.
 Launch the ATK Tool on development workstation.
 Select i.MX51_TO2 in i.MX CPU.
 Select DDR in Device Memory Initial.
 Select USB in Communication Channel.
 Click Next > Flash Tool > Go.
 Select Program in Operation type.
 Select MMC/SD in Flash Model.
 Set Operation Settings as 0x00000400.
 Specify the XLDR.nb0 in Image.
 Press the Program button to program XLDR in SD/MMC card
 Set Operation Settings as 0x00020000.
 Specify the EBOOT.nb0 in Image.
 Press the Program button to program EBOOT in SD/MMC card.
 Power off RSC-IMX51
 Set SW2 to boot from onboard flash.
 Power on RSC-IMX51. The EBOOT menu should be seen on the serial terminal.
 Exit the ATK Tool.