Avalue BFC-10R1 - Manual (Page 34)

RSC-IMX51
34 RSC-IMX51 User ’s Manual
3.5 Initialize EBOOT Network Configuration
To initialize EBOOT network configuration, follow these steps:
 Follow the steps in Section 3.4 “Program XLDR and EBOOT in on-board flash Using
ATK Tool,” to execute EBOOT on the target.
 Quickly switch over to the terminal emulation application and wait for the debug message,
Press [ENTER] to download now or [SPACE] to cancel to appear.
 Press the space bar to bring up the EBOOT configuration menu.
 Press K to disable KITL Enable mode
 Press 5 to s
elect Boot device to “NK from SD/MMC”
 Press 6 to specify an Ethernet MAC address by selecting the MAC Address menu option
and then entering the 12-digit hexadecimal MAC address delimited by periods.
 Press enter to return to the EBOOT configuration menu. The specified MAC address
should now be displayed in the EBOOT menu.
 By default, DHCP is enabled and there is no need to specify a static IP or static subnet
mask. If static networking parameters are needed, use the IP Address and Subnet Mask
menu options.
 After the desired network configuration appears in the EBOOT menu, select the Save
configuration menu option to save the configuration to nonvolatile memory.