Advanced Control Technologies Specs Instructions ZDW232 (RF 230 VAC, 500W, IncandescentWall Dimmer,Two Wire, White) - Manual (Page 6)

ZDW232 Instructions, Release 1.1
P/D 100407 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0747-01
6
The ZDW232 will flicker its LED when it is transmitting to any of its 4 groups. This flickering can be set to not
flicker at all (set to 0), to flicker the entire time it is transmitting (set to 1), or to flicker for only 1 second when it
begins transmitting (set to 2). By default, the ZDW232 is set to flicker for only 1 second.
Each Configuration Parameter can be set to its default setting by setting the default bit in the Configuration Set
command. See your controller’s instructions on how to do this (and if it supports it).
All Configuration commands will be reset to their default state when the ZDW232 is reset from the Z-Wave system.
Powerlevel
The ZDW232 supports the Powerlevel command.
The Powerlevel command allows controllers to set and get the RF transmit power level of a node and test specific
links between nodes with specific RF transmit power. Refer to your controller’s instructions, if it supports this
command, for more information. This command is typically used by professional installers.
SUC Support
There must be a Static Update Controller in your Z-Wave system for this feature to work. A Static Controller is one
that is not moved after addition to the network. The Static Controller can act as a gateway in the system, since other
nodes always know its position. The “always listening” advantage of the Static Controller is that other nodes can
transmit information frames to it whenever needed.
You can assign an “SUC Route” to the ZDW232. Refer to your Controller’s instructions on how to do this (if it supports
it). Assigning an SUC Route to the ZDW232 allows it to request an update of the Z-Wave devices that are between
it and the Z-Wave device to which it was trying to transmit. The ZDW232 will only request an update when a
transmission fails.
SPECIFICATION
Load: 25W to 500W maximum, for incandescent lamps only (Indoor use).
Signal Range: Up to 30 meters line of sight
Power: 230 VAC, 50 Hz.
Signal (Frequency): 868.42 MHz.
INTEROPERABILITY WITH Z-WAVE™ DEVICES
A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. The ZDW232 can be incorporated into existing Z-Wave™ networks.
The top or bottom of the switch on the face of the ZDW232 can be used to carry out inclusion, association, or
exclusion.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
Typical wiring schemes
25 to 500
Watt Load
Incandescent
ZDW232
25 to 500
Watt Load
Incandescent
ZDW232 L 1 2
1 2 N L
N