ADLINK Express-HL - Manual (Page 61)

Express-HL Page 61
Feature Options Description
Hot Plug Disabled
Enabled Designates this port as Hot Pluggable.
Mechanical Presence Disabled
Enabled Controls reporting if this port has an Mechanical Presence
Switch.\n\nNote: Requires hardware support.
External SATA Disabled
Enabled External SATA Support.
SATA Device Type Hard Disk Drive
Sold State Drive Identify the SATA port is connected to Solid State Drive or Hard
Disk Drive.
Spin up Device Disabled
Enabled On an edge detect from 0 to 1, the PCH starts a COMRESET
initialization sequence to the device.
7.3.5 USB
Feature Options Description
USB Module Version Info only
USB Devices Info only X Drive, X Keyboards, X Mouse, X Hubs
Legacy USB Support Enabled
Disabled
Auto Enables legacy USB support.
Auto option disables legacy support if no USB devices are
connected.
Disable option will keep USB devices available only for EFI
applications and setup.
USB3.0 Support Enabled
Disabled Enable/Disable USB3.0 (XHCI) Controller Support.
XHCI Hand-off Enabled
Disabled This is a workaround for OSes without XHCI hand-off support. The
XHCI ownership change should be claimed by the XHCI OS driver.
EHCI Hand-off Enabled
Disabled This is a workaround for OSes without EHCI hand-off support. The
EHCI ownership change should be claimed by the EHCI OS driver.
USB Mass Storage Driver Support Enabled
Disabled Enable/Disable USB Mass Storage Driver Support.
PCH USB Configuration Submenu
USB hardware delays and time-outs: Info only
USB transfer time-out 1 sec
5 sec
10 sec
20 sec The time-out value for Control, Bulk, and Interrupt transfers
Device reset time-out 10 sec
20 sec
30 sec
40 sec USB mass storage device Start Unit command time-out.
Device power-up delay Auto
Manual Maximum time the device will take before it properly reports itself to
the Host Controller. 'Auto' uses default value: for a Root port it is 100
ms, for a Hub port the delay is taken from Hub descriptor.
Mass Storage Devices Info only List current USB max stroge device.