ADLINK ND-6017 - Manual (Page 58)

50 • Command Set
3.13 Offset Calibration
@Description
To correct the offset errors of AD converter by using the offset
calibration.
@Syntax
$(Addr)1
$ Command leading code
(Addr) Address ID
1 Offset calibration.
@Response
!(Addr)
or
?(Addr)>
! Command is valid.
? Command is invalid.
(Addr) Address ID.
@Example
User command: $061
Response: !06
To perform the offset calibration for analog input module at specified
address 06 (Hex).
Note: To perform the calibration, a proper input signal should be
connected to the analog input module. Different input range
have different input voltage, detail refer chapter 5
“Calibration” .
(6011/D, 6012/D, 6013 C4.6
and above, 6014D, 6017, 6018)