ADLINK PCI-7300A - Manual (Page 71)

C/C++ Libraries 59
5.3 _7300_Initial
@ Description
A PCI-7300A card is initialized according to the card number.
Because the cPCI/PCI-7300A is PCI bus architecture and meets
the plug and play design, the IRQ and base address (pass-
through address) are assigned by system BIOS directly. Every
cPCI/PCI-7300A card has to be initialized by this function before
calling other functions.
Note: Because configuration of cPCI/PCI-7300A is handled by the
system, there is no jumpers or DMA selection on the PCI
boards that need to be set up by the users.
@ Syntax
Visual C/C++ (Windows 95)
int W_7300_Initial (int card_number, int
*pcic_base_addr, int *lb_base_addr, int
*irq_no, int *pci_master)
Visual C/C++ (Windows 95)
W_7300_Initial (ByVal card_number As Long,
pcic_base_addr As Long, lb_base_addr As
Long, irq_no As Long, pci_master As Long) As
Long
C/C++ (DOS)
int _7300_Initial (int card_number, int
*pcic_base_addr, int *lb_base_addr, int
*irq_no, int *pci_master)
@ Argument
card_number:the card number to be initialized, only four cards
can be initialized, the card number must be CARD_1, CARD_2,
CARD_3 or CARD_4.
pcic_base_addr:the I/O port base address of the PCI controller
on card, it is assigned by system BIOS.
lb_base_addr:the I/O port base address of the card, it is
assigned by system BIOS.