beautypg.com

18 series installation - separate units, Ab c – Delta 48313 User Manual

Page 6

background image

1

Jetted Shower XO™ Jet Module Trim Installation

A.

Turn off water supplies. Unscrew test

caps (1) from the body. If this is not a thin

wall mounting, the entire plasterguard may

be removed.

IMPORTANT: NOTE COLOR

OF BASE ON STEM EXTENDER (2) FOR

USE LATER. (SEE CHART BELOW FOR

REFERENCE.)

18 Series Installation - Separate Units

B.

1

1

1

3

A

B

C

2

3

4

5

Select proper label (1), the 3 position

label B (used with the blue stem

extender) or 6 position label C (used with

the black stem extender) and assemble

onto trim ring (2). (Refer to chart below

for proper label selection.) Slide trim ring

onto sleeve (3) until it bottoms out on the

escutcheon (4). Install handle (5) onto

stem, tighten set screw to secure. Thread

the bonnet assemblies (6) onto the jet

sleeve assemblies (7).

1

Jetted

Shower™

Jetted Shower

XO™

2 Ports

3 Ports

Stem
Extender

White

Blue

Black

Label

A

B

C

6

7

6

Thread sleeve (1) onto brass body,

use wrench to tighten. Place the oval

escutcheon (2) over jet body module.

Thread the jet sleeve assemblies (3) onto

the jet body module. Use wrench (4) to

tighten the sleeve assemblies.

CAUTION: DO NOT OVERTIGHTEN.

TIGHTEN UNTIL THE ESCUTCHEON IS

FLAT AGAINST THE WALL.

C.

4

2

4

2