Delta 48313 - Manual (Page 3)

Single Handle Monitor ®
MultiChoice ® Jetted
Shower™ Trim
Installation Instructions
Owners Manual
18 & 18T
Series
Write purchased model number here.
ASME A112.18.1 / CSA B125.1
ASSE 1016
®
®
U P
C
THIS VALVE MEETS OR EXCEEDS THE
FOLLOWING STANDARDS:
ASME A112.18.1/CSA B125.1 and ASSE 1016.
CAUTION: This system/device must be set by the
installer to ensure safe, maximum temperature.
Any change in the setting may raise the discharge
temperature above the limit considered safe and
may lead to hot water burns.
NOTICE TO INSTALLER: CAUTION!–As the
installer of this valve, it is your responsibility
to properly INSTALL and ADJUST this valve
per the instructions given. This valve does
not automatically adjust for inlet temperature
changes, therefore, someone must make the
necessary Rotational Limit Stop or temperature
knob adjustments at the time of installation
and further adjustments may be necessary
due to seasonal water temperature change.
YOU MUST inform the owner/user of this
requirement by following the instructions. If you
or the owner/user are unsure how to properly make
these adjustments, please refer to page 8 and
14 (18 series) or page 20 (18T series) and if still
uncertain, call us at 1-800-345-DELTA.
After installation and adjustment, you must affix
your name, company name and the date you
adjusted the Rotational Limit Stop or temperature
knob to the caution label provided and apply or
attach the label to the back side of the closest
cabinet door and the warning label to the water
heater. Leave this Instruction Sheet for the
owner’s/user’s reference.
WARNING: This pressure balanced or
thermostatic bath valve is designed
to minimize the effects of outlet water
temperature changes due to inlet pressure
changes, commonly caused by dishwashers,
washing machines, toilets and the like. It may
not provide protection from hot water burns
when there is a failure of other temperature
controlling devices elsewhere in the
plumbing system, if the rotational limit stop
or temperature knob is not properly set or if
the hot water temperature is changed after the
settings are made or if the water inlet changes
due to seasonal changes.
WARNING: Do not install a shut-off device on
either outlet of this valve. When this type of
device shuts off the water flow, it can defeat
the ability of the valve to balance the hot and
cold water pressures.
Table of Contents:
Warranty ............................................................................. Page 2
18 Series Installation Instructions
Separate Units - T18430 & T18455 Series ...................... Pages 3 - 8
Single Units - T18230, T18240 & T18255 Series ............. Pages 9 - 14
18T Series Installation Instructions ..................................... Pages 15 - 20
Maintenance ....................................................................... Page 21
Replacement Parts ............................................................. Pages 22 - 29
1
You May Need
TE
FLON
11/12/08 48313 Rev. D